Engine & Battery

Fluid is dispensed under pressure for smooth continual flowIntegrated manual pump adds air above the fluid level to prevent aerationInternal pump components are sealed against exposure to fluidsFlow control valve is conveniently located near fluid...

25A Battery Charger. The all-new GENIUSPRO25 - Similar to our G15000, just more powerful. With the greatest performance and functionality yet, it's a world-class battery charger to let professionals push the limits at incredible charging speeds. Do more...

4-Bank 40A Onboard Battery Charger A four-bank on-board battery charger rated at 40-amps for 12-volt batteries, including marine, boat, starter, and deep-cycle batteries. Charging modes - Independently charge and control each battery bank with...

Holds the engine when replacing the timing belt. For vehicles with the 8-speed automatic TG-81SC transmission. Kit includes: Position setting, Puller, Counter hold, Drift & Counter hold. Applications: 2.0L - S60, S80, V60, 70, XC60, XC70 & XC80...

OTC GM Truck and SUV Crankshaft Seal Remover Save time removing crankshaft rear seals, preventing damage to the block and crank. This seal remover is a special puller with three jaws designed to grab the inner lip of the seal. The forcing screw attached...

6L Transmission Filler and Extract Kit Designed for undercar transmission fluid service. All connections are simply press-on quick connects for ease of use. The 6-liter sealed reservoir is used with shop air to extract or dispense transmission fluid...

Used on Sprinter vehicles with V6 diesel engines that use M8×1.0mm glow plugs which have broken off in the cylinder head. Kit contains breaking socket, 3 flute step drill, and thread tap/chaser. Used with the MU121 slide hammer (sold separately)...

Used for holding the camshafts in the timing position during gearwheel installation and for turning the crankshaft during installation and removal Includes: Camshaft Adjusting tool, Camshaft Holding Wrench, Camshaft Adjusting Wrench, TDC Locating Pin...

Automatic Charging of Multiple Battery Types 60/40/10A Charging for 12V Batteries 20/10A Charging for 24V Batteries 250A Engine Start Assistance, 12V Adjustable 13.1 - 14.9V Stable Power Mode, 60 Amps Max 12V Adjustable 26.2 - 29.8V Stable Power Mode,...

Kit includes necessary components required to perform a full timing service Used for the alignment the engine camshaft position Also holds the engine crankshaft position Designed for the T6 Engine (3.0T & 3.2T) 2007+ Applications: Land Rover, Jaguar...

Removes the rear seal and wear ring from crankshaft Similar to OE part number 303-771

Crankshaft Front Seal and Wear Ring Remover