Brake & Wheel

C-Frame press, 3 receiver tubes, removal and installation adaptors. # Removes and installs press-fit parts such as ball joints, universal joints, and truck brake anchor pins. # Contains: 3 receiver...

Removes front hubs without damaging the wheel bearing. Its universal design fits most FWD cars. The spare locknut lets you use it with a standard slide hammer puller for rear axle flanges.

Designed for installing wheel bearing cups of tractor/trailer wheels from 11000 to 50000 lb. capacity. A Adjust and lock the jaws to the cup I.D., slip on the new cup, put it all in place, then hit...

Dana 60 Dana 50IFS",Applications: 1985 1/2-1995 Ford F-series H.D. 3/4 and 1 ton Dana 50 IFS or Dana 60 front axle 1985-1995 Ford F-series 1/2 ton truck and full size Bronco with Dana 28 front axle

Services 1978–84 Ford F-series H.D. 3/4-and 1-ton 4WD trucks; 1973–81 GM 3/4- and 1-ton 4WD trucks. 1/2" sq. drive. Wt., 1 lb., 11 oz.

FRONT COIL SPRING COMPRESSOR

DISC BRAKE PAD SPREADER

Handles large components such as brake drums, rotors, drive wheels, gears, flywheels, and pulleys. One person can easily set the tool in place and use for tough pulls even where there is little...

# Required for use with No. 6735 Sprinter Van Ball Joint Kit. When used with OTC No. 6730 Update Kit, you can expand the applications of OTC Nos. 7249, 7918, and 6530 Ball Joint Kits.

Four-piece kit designed to be used with the industry standard OTC No. 7248 C-frame. Contains specialty ball joint adapters to fit the following GM vehicles: TrailBlazer & Envoy 2002-2005 Suburban &...

Kit contains two adapters which, when coupled with the large C-frame included in OTC No. 8031 SUV Ball Joint Kit, make it possible to use any adapter designed for use with the smaller OTC No. 7248/49...

54mm hex locknut socket Designed for use on front wheel adjusting nuts found on Toyota FJ, LN, and RN models Features a 1/2 inch square drive Can be used with an extension and torque wrench for...