Brake & Wheel

The No. 8149 tool is designed to fit Pitman arms on compact and intermediate cars. Conical design fits securely on Pitman arm.3/4-16 x 4-3/4" forcing screw provides enough power to remove stubborn Pitman arms.

The proportioning valve depressor works on various GM utility vehicles, vans, and pickups fitted with Kelsey Hayes anti-lock brake systems. It also works on rear-wheel anti-lock brakes. Two depressors work best for four-wheel anti-lock systems.

Before servicing a torsion bar on 1995–2001 Ford Explorer and 1998–2001 Mercury Mountaineer vehicles, you must first contain the bar to avoid possible damage.

This kit is used with ball joint service kit No. 7249 to remove and install upper and lower ball joints on 1967-current 1/2- and 3/4-ton 4WD vehicles having the Dana44 front axle (found on Ford, GM, Dodge, IHC and Jeep vehicles).

This heavy-duty slide hammer puller gets tough with those really stuck parts. Heat treated, 24" long, and a 5/8"-18 threaded end to adapt to any of OTC's pulling attachments. Ten-pound hammer

The next time a job requires removing either front or rear disc brakes, these hangers will pay for themselves in convenience alone Any time there`s brake, wheel bearing, axle shaft, or suspension service to do, these hangers hold the brake calipers out...

This is the puller you need for CV work on many Ford cars. Used with a slide hammer, it will remove an axle assembly from the transaxle without causing damage to expensive aluminum transmission cases or other components.

CV joint fork only. Use with OTC slide hammer No. 1155, extension, OTC7508, or both.

Works on FWD and RWD import and domestic vehicles. Up to 5 tons of force can be applied.

This puller enables you to remove the front spindle on light-duty 4WD trucks. It’s designed for full-size Ford, GM, International, and Jeep pickups with Dana front axles. Also works on Ford Ranger and Bronco II. 5/8" fine thread makes it ideal for use...

Easily removes stubborn heavy-duty U-joints on Dana and Rockwell® driveshaft assemblies.

3/4" Drive x 41mm 12 Point Standard (Fits BMW Bottom Ball