Chassis

Use for removing and installing the top shock retaining nut on S40, S60, S70, S80, S90 models Includes holding socket and double-D axle center socket Double-D measures 8mm "flat-to-flat" Use 10mm hex wrench on top of Double-D socket Use 28mm hex wrench...

Special oval shaped bit end services Suspension Strut Housing Nuts found on some VW & Audi models Also fits some BMW, Seat, Renault, Peugeot 3/8" square drive

Press tool removes and installs control arm bushings without having to remove the control arm from the car.See application chart for compatible vehiclesSecond generation (E30; 1982–1994)Third generation (E36; 1990–2000)Fourth generation (E46;...

For lower control arm ball joint service on Volvo S60 ('01 - '10) S80 ('99 - '06) V70 ('00 - '07) XC70 ('02 - '07) XC90 ('03 - up) XC60 ('09 - up) Includes 3 adapters - M12 x 1.75, M14 x 1.5, M14 x 2.0

Holds torsion bar while making adjustments. Services '88 - '03 GMC and Chevrolet 1/2-ton, 3/4-ton & 1-ton pickups, S-10 Blazer, S-15 Jimmy, 4WD pickups w/ 4. 3L V6 engine & '91 - '01 Oldsmobile, Bravada.

Brake Fluid Tester for DOT 4 Determines quality of brake fluid. Measures moisture form 0%-4%. LED lights to show moisture percentage. Automotically shuts off after 12 seconds. 1.5V AAA battery included.

Stepped Design on the Forks Keeps the Tool from Bouncing Back when Separating Ball Joints, Steering Dampeners, Tie Rods, Pitman Arms and Other Applications. Includes five forks: 11/16", 15/16", 1-1/8", 1-7/16" and 1-5/8". Forks are threaded to...

Separator Set features solid construction pickle forks in 5 popular sizes. Used to remove ball joints, tie rods, pitman arm, and other linkages. One piece design ensures durability, rigidity, and complete transfer of hammering forces. Included are the...

This helpful tool uses a forcing-screw press to safely remove and replace automotive universal joints with needle bearings, including GM plastic pin CV U-joints. 

Driver Set Includes: 8 Drivers for Driving Inner and Outer Pinion Bearing Races on 1/2 & 3/4 Ton Ford, Dodge and GM Pickups. Use the extended, two-piece handle for driving rear pinion bearing races. A pneumatic handle is also included for use with...

Ball Joint Receiver Tube 2-7/8" O.D x 2-5/8" x 2-7/8"2-7/8" O.D x 2-5/8" x 2-7/8" Use with a C-Frame press for ball joint R&R

Quickly Removes the U-Joint Cap from the Drive Shaft on Most Rear Wheel Drive Vehicles. Use the driver with an air hammer to remove u-joint caps up to 1-5/16" diameter. Prevents damage to drive shaft and axle shaft ears, when presses or chisels are used...