Engine & Battery

Ensure replacement injectors and seals are installed correctly. This kit installs the dual seals onto the end of the injector. These seals must be installed into their grooves, and then sized to the engineered dimension before the injectors are installed...

Used for holding the crankshaft & camshafts when removing & installing timing components. Sets the engine in the proper position in order to perform engine service. Included components: Camshaft locking blocks, Flywheel locking pins, Timing...

OTC GM Injector Seal Installer and Sizer Adapters Ensure replacement injectors and seals are installed correctly. This kit installs the Teflon seal onto the end of the injector. The pilot cone is placed onto the end of the injector and the seal is...

Designed to removes broken exhaust manifold studs or bolts on 2000-2007 Dodge, Jeep 4.7L engines without removing the cylinder head. Tapered bolts center base plate over bolt holes and slip fit bushing allows you to move from hole to hole without moving...

2-Bank 10A Onboard Battery Charger Multiple-banks- A two-bank on-board battery charger rated at 10-amps (5-amps per bank) for 12-volt batteries, including marine, boat, starter, and deep-cycle batteries. Independently charge and control each battery...

Transmission Filling Adapters Set The 14-piece transmission fill adapters kit includes OE-style transmission filling adapters, covering most imported vehicles and special design domestic applications. Asian and European adapters cover Audi, VW, Porsche,...

Splits and reconnects single & double row timing chains on Mercedes Benz gas and diesel engines Services M276 & M278 (2012+) Use in conjunction with CTA 1095

OTC Fuel Tank Adapter A gas tank and gas cap adapter for diagnosing tanks with conventional threaded type fuel filler caps. Designed to be used with EVAP system tester. Includes a male tank adapter and female cap adapter connected by a 40" hose...

CTA 6 Piece Spark Plug & Glow Plug Socket Set For removal and installation of Spark Plugs, Glow Plugs & Pressure Sensor Glow (PSG) Plugs. Included sizes: 8mm x 6-point, 9mm x 6-point, 10mm x 6-point, 12mm x 6-point, 14mm x 12-point & 16mm x...

Press fit front seal to engine block & crankshaft for proper fitment of inner & outer seal body (works w/ 3878) Services GM/ISUZU 6.6L Duramax 2001+ GMT800, 2500HD & 3500. Installation instructions: Set new seal on inner body of tool Attach...

Dipstick Extractor Kit Ford Dodge GM Extracts broken dipstick tubes on Ford (4.6L, 5.4L, 6.2L & 6.8L), Dodge (5.7L & 6.1L) & GM (4.8L, 5.3L, 5.7L, 6.0L & 6.2L) V8 engines. When the dipstick tube breaks off, a piece remains at entry...

CTA Cummins Sleeve Installer Kit - 3.9L 5.9L & 6.7L Use for 3.9L, 5.9L & 6.7L Cummins engines when wear sleeve is installed or replaced Services Paccar PX-6, 1989-2016 Cummins 4BT 3.9L, B Series 5.9L, ISB 5.9L 6.7L and QSB 5.9L 6.7L Includes CTA...