Engine Service

For R&R of Fuel Filter, Fuel Lines, Engine and Transmission Cooler Lines. Includes #'s 8012 | 5/16" Ford Fuel Filter Remover, 8013 | 3/8" Ford Fuel Line Remover, 8016 | 1/2" Dodge Oil Cooler Line Remover, 8021 | 3/8" Oil Cooler Line Remover, 8022 | ...

Removes Broken Exhaust Manifold Bolts on GM LS III 4.8L, 5.3L and 6.0L Motors Without Damaging the Cylinder Head. Tapered bolts center base plate over bolt holes and slip fit bushing allows you to move from hole to hole without moving base plate. The...

Test-Vac Vacuum Test Kit allows fast, efficient testing and monitoring of many vacuum operated components and also allows one man brake bleeding. The new kit can help find vacuum leaks, test fuel, engine and exhaust valves, door locks, and...

Locks the flywheel while the transmission is removed for service. Comparable to BMW factory tool # 119260.

11mm x 1.5D Honda Head repair kit fixes Head Bolt threads specifically designed for Honda, Toyota and Other Imports The kit provides longer thread inserts for maximum thread engagement Honda head repair kit comes with: 1 Piece HSS drill bit, 1 Piece STI...

Installs the front crank seal with the cover on or off the engine. The bolt is threaded into the crankshaft and the nut is tightened to seat the seal. Similar to EN-50820 & EN48034. Applications: 2013-14 Cadillac ATS, 2014 Cadillac CTS, 2013-14...

Verifies that the camshaft fuel pump lobe is at base circle position before installing the high pressure fuel pump. Tool indicates the pump may be installed when it is flush to manifold surface. Similar to EN-51092. Applications: 2014-15 Chevrolet...

Oversized retaining plates lock camshafts together at top dead center (TDC) on GM 2.8L 3.0L and 3.6L DOHC engines. Three-plate set is used to tighten both sets of cams to prevent them from turning while setting timing. Extra-large size prevents valve...

Designed for BMW cylinder head bolts 1/2" square drive bits are extra long (OAL 230mm) Allows access to reach down and remove stubborn cylinder head bolts T60 is for BMW applications

Designed for BMW cylinder head bolts 1/2" square drive bits are extra long (OAL 200mm) Allows access to reach down and remove stubborn cylinder head bolts T50 is for BMW applications

Two-piece kit includes tools to properly size the seal and install the seals in the proper groove on the injector tip for leak-free operation. Works to install both seals on the injector tip. Similar to EN-51105. Applications: 2014-15 Chevrolet Silverado...

Use for everyday drain plug replacement requirements Manufacturers recommend replacing Oil Drain Plugs with every oil change