LISLE CORPORATION

The pipe stretcher kit is a convenient, inexpensive alternative to hydraulic pipe expanders. Comes in a molded storage case. Stretches Pipe up to 4-1/4" Including Stainless Steel. Use with an impact...

Curved Hose Clamp Pliers Cross-Cut Tip Design that Grip Most Hose Clamps from Multiple Angles. Ergonomic curved design making pliers easy to use in hard-to-reach areas. Ratcheting lock mechanism...

Cross-Cut Tip Design that Grip Most Hose Clamps from Multiple Angles. Ergonomic curved design making pliers easy to use in hard-to-reach areas. Ratcheting lock mechanism holds the clamp in an open...

Drives Camshaft Bearings Smoothly. One complete set that will remove or insert camshaft bearings in nearly all engines from compact cars to heavy trucks. Range of 1.125" to 2.69" (28.58 - 68.3mm)...

Small Engine Ring Compressor For Small Cylinders: 1 1/2" to 3" (38.1-76.2mm) Quality tool at a low price.

Stepped design helps keep tool from bouncing back. 18520 is used to replace worn out tie rods and to separate shock absorber links. The tine opening is 11/16". These heavy-duty tools are drop forged...

Stepped design helps keep tool from bouncing back. The 18530 is used to replace worn out ball joints and to remove CV drive shafts on FWD vehicles. The tine opening is 15/16". These heavy-duty tools...

Protects Arms from Burns While Working Around the Engine. Made of durable, heat-resistant Kevlar®. Double wall construction for added heat protection. Will protect hand and forearm from hot objects...

Quickly Removes the U-Joint Cap from the Drive Shaft on Most Rear Wheel Drive Vehicles. Use the driver with an air hammer to remove u-joint caps up to 1-5/16" diameter. Prevents damage to drive...

Everything needed to quickly bleed brakes with no mess. Plastic bottle collects discharged fluid. Three separate adapters fit the common bleeder screws.

Set Ranges 1/4-9/16","The 6 piece set removes standard and metric bolts, nuts and studs from 1/4"" to 9/16"" (6mm to 14mm). Drive the proper size remover over the bolt head, nut or stud. The remover...

With the engine running, place the grooved end of the tool over the plug wire. The bulb will flash to indicate spark.