Engine & Battery

Disconnect tool is required to remove the fuel line connector from the fuel filter on the GM 5.3L V8 Engine. Applications: Avalanche, Tahoe, Silverado, Savana, Trailblazer and more. Visit ctatools.com for application details.

VVL only, not for VVT engines. This set is for the newer models that have VVL (Variable Valve Lift). If working on a Pentastar that is VVT (Variable Valve Timing) see the CM5000. 2016-present Jeep Grand Cherokee 2016-present Dodge...

Tracer Gas Leak Detector Service Kit Kit gives technicians the tools necessary to use tracer gas in place of refrigerant to find A/C system leaks. Includes a hydrogen gas leak detector with sensor technology designed to detect a 5% hydrogen...

This tool installs the front and rear crankshaft wear sleeves and seals. It eliminates lip flare on the wear sleeve and installs the seal properly.  For use on Detroit Diesel Series 60 and two cycle 92 engines.  Similar to J35686B

Fully automatic operation 40/20/2/230A 40 Amp 12V fast charge rate 10 Amp 12V medium charge rate 2 Amp 12V low charge rate 20 Amp 24V fast charge rate 2 Amp 24V low charge rate 230 Amp 12V engine starting assistance Digital display with 7-segment...

Services the timing system on 4.0 L SOHC V6 Engine. Required for replacing the timing chain when the poorly designed original Teflon chain guides fail. Signs of failure are heard as a louder engine note during a cold start and between 2400 - 3000 RPM...

Removes the front seal and wear ring from crankshaft. Similar to 303-1260.260. Applications include: 2008-2010 Ford F-250, F350, F450, F-550 6.4L Ford Powerstroke engines VT365-MaxxForce7 Navistar International

VAG Timing Tool Kit - 1.8L & 2.0L (TSI / TFSI) includes the following: #1032 - 3 Pc. V.A.G. Camshaft Adjusting Socket Set - 2.0L (TFSI), #2889 - VW/Audi 2.0T Timing Kit - 2.0L (TFSI) & #8064 - VW Chain Tensioner Lever. Needed for EA888...

Locks camshafts and crankshaft in position when servicing the timing chain and setting engine timing A properly working timing system allows the engine's valves to open and close at the proper times during each cylinder's intake and exhaust strokes...

Chrysler 3.6L Timing Chain Tools   The CRY360 includes 2 Camshaft phaser locks (left and right banks) three timing chain holders (one left bank and two right hand versions) and tensioner pins. The CRY360 includes 2 Camshaft phaser locks (left and...

Set includes tools to remove fuel injector sleeves, clean the injector bore and fuel galley, and install injector sleeve cups. With the head removed, the slide hammer adapter can be installed to pull the injector sleeve. The brush set properly cleans the...

Removes transmission extension housing bushing. The tool is inserted through the bushing and the drive screw is tightened to draw the bushing out of the housing. Similar to 308-070. Applications include Ford Ranger transmissions: 4R44E/4R55E ...