OTC ROBINAIR BOSCH

2 Pc Brass Punch Set

This chrome vanadium hardened steel wrench features a 9" handle and slim strong hook to access slotted retaining rings in hard to reach areas.

Use with a heat gun or flameless torch to secure electrical connections from harsh environments Allows for easy splicing of wires without the need of electrical tape Protection and insulation for...

This kit contains the tools to remove and install inner cam bearings without damage to the crankcase. The bearing puller is designed to trap the needle bearings and keep them from falling into the...

Cram/Crank Locking Tool

Easy-to-use compression tester is designed specifically for medium-duty diesel engines equipped with glow plugs. Dual reading gauge measures compression to 1000 psi and 7000 kPa. Gauge has a...

Oil seal and wear ring installer for 5.0 inch diameter seals Makes the difficult job of correctly installing the rear crankshaft seal and wear ring on most Navistar DT-360 and DT-466 engines thru...

2 Pc Truck Clutch Adjustment Gage Set

Air-Assisted 2,000 lb. Capacity High-Lift Transmission Jack for Trucks and Buses For shops with in-ground or above-the-floor vehicle hoists. Covered by OTC Lifetime Marathon Warranty®. Low height of...

Tools used to separate connectors on the P/S system and EGR coolers without damage. Also works on connectors on other liquid and air lines. Similar to J-45666 & J-42971. Applications: 2003-later...

U-Joint Puller

Heavy Duty Bearing Cup Installer