OTC ROBINAIR BOSCH

This 4-adapter set is used in conjunction with the 7248 C-frame to remove and install ball joints on select Acura and Honda vehicles. Set contains adapter part numbers 580518, 554419, 554414 and...

This press separates the lower control arm ball joint from the steering knuckle.  Applications include many 1998 - later Ford, Lincoln, & Mercury vehicles. Similar to 204-592.

Ball Joint Remover

This tool set holds the timing belt in three locations during water pump removal and installation.  Used in conjunction with Top Dead Center Pin p/n 567643.  Applications include; ...

Harmonic Balancer Puller Kit

Ford 3V Valve Spring Compressor

Oversized retaining plates lock camshafts together at top dead center (TDC) on GM 2.8L 3.0L and 3.6L DOHC engines. Three-plate set is used to tighten both sets of cams to prevent them from turning...

Pitman Arm Puller Set

Used for removal of the direct injection fuel rail without damage. The rail assembly must be removed as straight as possible to prevent damaging an injector bore in the cylinder head or the mount...

Two-piece kit includes tools to properly size the seal and install the seals in the proper groove on the injector tip for leak-free operation. Works to install both seals on the injector tip. Similar...

Verifies that the camshaft fuel pump lobe is at base circle position before installing the high pressure fuel pump. Tool indicates the pump may be installed when it is flush to manifold surface...

Specialty locking pliers provide brake line bending on vehicles in tight locations. Bending jaws run perpendicular to plier jaws, allowing for 360-degree bends in brake lines. The included 10”...