OTC ROBINAIR BOSCH

OTC GM Truck and SUV Crankshaft Seal Remover Save time removing crankshaft rear seals, preventing damage to the block and crank. This seal remover is a special puller with three jaws designed to...

OTC Crankshaft Rear Seal Installer Prevent leaks by properly aligning and installing crankshaft rear seals. This seal installer is a two-piece tool that mounts to the crankshaft and places force on...

Ensure replacement injectors and seals are installed correctly. This kit installs the dual seals onto the end of the injector. These seals must be installed into their grooves, and then sized to the...

OTC GM Injector Seal Installer and Sizer Adapters Ensure replacement injectors and seals are installed correctly. This kit installs the Teflon seal onto the end of the injector. The pilot cone is...

Installs the front crank seal with the cover on or off the engine. The bolt is threaded into the crankshaft and the nut is tightened to seat the seal. Similar to EN-50820 & EN48034. Applications:...

GM Duramax Injector Puller

Designed to pull injectors on a GM Duramax 6.6L engine, 2005 - 2011. Similar to J-46594 -J46594

Adapts to fuel system for use during pressure testing and diagnostic procedures. For use on 2003-Later 5.9L Cummins Diesel. Similar to OE part number MLR-9011.

OTC Chrysler EVAP Leak Check Adapter Designed to be used with EVAP system tester. Includes a male tank adapter and female cap adapter connected by a 20" hose. Applications include: 2006-Later...

OTC Fuel Tank Adapter A gas tank and gas cap adapter for diagnosing tanks with conventional threaded type fuel filler caps. Designed to be used with EVAP system tester. Includes a male tank adapter...

Diagnose all GM 5/16" EVAP line systems. This adapter connects into the EVAP system line at the canister quick-connect fitting. An EVAP port fitting allows EVAP system testing and diagnosis. Use with...

Designed to separate oil pan seals, the cutter is pressed into the sealant and struck with a hammer to cut through the oil pan seals. Other methods may damage the oil pan and/or sealing surfaces...