OTC ROBINAIR BOSCH

This press separates the lower control arm ball joint from the steering knuckle.  Applications include many 1998 - later Ford, Lincoln, & Mercury vehicles. Similar to 204-592.

Ball Joint Remover

This tool set holds the timing belt in three locations during water pump removal and installation.  Used in conjunction with Top Dead Center Pin p/n 567643.  Applications include; ...

Ford 3V Valve Spring Compressor

Oversized retaining plates lock camshafts together at top dead center (TDC) on GM 2.8L 3.0L and 3.6L DOHC engines. Three-plate set is used to tighten both sets of cams to prevent them from turning...

Pitman Arm Puller Set

Used for removal of the direct injection fuel rail without damage. The rail assembly must be removed as straight as possible to prevent damaging an injector bore in the cylinder head or the mount...

Two-piece kit includes tools to properly size the seal and install the seals in the proper groove on the injector tip for leak-free operation. Works to install both seals on the injector tip. Similar...

Verifies that the camshaft fuel pump lobe is at base circle position before installing the high pressure fuel pump. Tool indicates the pump may be installed when it is flush to manifold surface...

Makes replacing engine drive belts and starter generators easier. This tool compresses the belt tensioner spring during engine drive belt replacement and starter generator servicing. Applications...

OTC GM 2.8L and 6.6L Diesel Fuel Line Release Tool Save time servicing fuel line bundle or replacing fuel lines. This quick-connect release tool is designed to separate the 4.8mm (3/16 inch)...

OTC GM Truck and SUV Crankshaft Seal Remover Save time removing crankshaft rear seals, preventing damage to the block and crank. This seal remover is a special puller with three jaws designed to...