Chassis

Addresses the most common issue of tightening the top mount nut while holding the strut. Allows for proper torque to be applied to the top nut. Constructed of Chrome Vanadium. Includes: 82mm Deep Sockets sizes: 16, 17, 18, 19, 21, 22 & 24mm. 4 Hex...

Includes a 7" Driver for Applications with Limited Access.Pneumatic bushing driver set removes and installs truck and trailer 1-3/8" anchor pin bushings and stuck anchor pins.Double sided cone snaps onto driver to drive out and install bushings. Use...

Inner Tie Rod Tool

Used for installing a ball joint on a lower control arm Eliminates the need for an extra pair of hands Works with any 7/8” diameter pry bar Works on Domestic, European & Asian vehicles Larger hook end grabs hold of the control arm and the smaller...

For use on all types of tailpipes, mufflers and exhaust systems. Designed to quickly and easily straighten out clamp dents in mufflers and tailpipes. A simple wrench turn expands the pipe for exhaust system repair and installation. Works with all 1-1/8"...

Removes outer seal on input shaft. The tapered thread end is threaded into the seal ID and the forcing screw is tightened to pull the seal from its seat. Similar to 307-673. Applications include: 6-Speed PowerShift Transmission 2011-Later Ford...

Pitman Arm Puller

The Astro Pneumatic Tool 78830 Heavy Duty Drum and Rotor Puller Kit is used with a 1-1/4" socket and 1-1/4" or 32mm wrench to remove hubs, drums and brake rotors. This tool’s durable forged design is made from the same alloy as Astro's famous ball joint...

For disassembling even the most seized U-joints in minutes on most intermediate trucks, school buses, farm and light industrial vehicles. Eliminates dangerous vice and socket or hammering methods. Reduces risk of damage to the driveshaft, yokes, joints...

Impact driven Heavy-Duty expander allows for fitting smaller exhaust piping and making exhaust seals The 28mm drive tool and collet sets expand pipes from 1-5/8" to 4-1/4"  Includes: Steel expander 1 5/8" - 2" Collet Steel expander 2" - 2 1/2"...

Standard .401 turn type parker shank for air guns. Fully hardened and tempered shock resistant tool steel. Black oxide finish to prevent corrosion. Set includes the following: OD Pipe Cutter x 8-1/4", Pipe Remover x 8-1/4", 3/8" Nut Splitter 3/4" x 6",...

Set includes 3 bearing pullers with a range from 1" up to 2-7/8". Designed to remove flange type, semi-floating rear axle bearings in most late model, rear-whell drive cars and light trucks. Designed to capture rear axle bearings firmly. Durable...