Chassis

The 6637 Strut Tamer II Extreme sets the standard in strength and safety for strut spring compressors. This unit meets the new ASME PASE safety standards for spring compressors and is capable of safely compressing the largest strut springs. Forged...

Checks ball joint wear and disc rotor run out Checks tire and wheel run out, gear backlash, valve guide wear, etc. Meets state inspection requirements Dust, water and oil resistant indicator features 0-1" travel, and .001"/.01mm graduations Includes...

Holds torsion bar while making adjustments Services 2011 and up HD C/K trucks Forged construction with bright blue body

Special selected sizes to provide usually needed sizes for larger automotive, SUV, light truck service. All discs are 1/2" thick. Disc sizes: 3 1/16" to 4 1/2"

The 20% Thicker Fork Design Provides Extra Lift When Replacing Worn Out Ball Joints, Pitman Arms, Pickup Track Bars and Other Includes five forks: 11/16", 15/16", 1-1/8", 1-7/16" and 1-5/8". Forks are threaded to interchange with either the handle for...

Releases the Lower Ball Joint on Audi A4 ('07 & up), A5 ('09 & up), A6 ('11 & up), A7 ('10 & up), Q5 ('10 & up). Allows the ball joint to be turned after releasing the pinch bolt. Features 1/2" square drive with 27mm hex & 18mm...

R&R Was Never Easier and Faster Front wheel bearing adapters replace wheel bearings while keeping the steering knuckle and strut assembly in tact on the vehicle The set eliminates the need for front end alignment once the work is done Use on front...

For removal of most types of pitman arms, tie rods and ball joints found on automotive and light truck applications.

Services Sprinter Ball Joints. Black Finish With 3/4" Square Drive. Od--68Mm, Id--50MmServices Sprinter Ball Joints3/4" Square DriveOd--68Mm, Id--50MmBlack Finish6 Pin Design

Services Benz M-Class (W163/W164) Ball Joints. Black Finish With 3/4" Square Drive. Od--63Mm, Id--50MmServices Benz M-Class (W163/W164) Ball Joints3/4" Square DriveOd--63Mm, Id--50MmBlack Finish4 Pin Design

Use for removing and installing the top shock retaining nut on S40, S60, S70, S80, S90 models Includes holding socket and double-D axle center socket Double-D measures 8mm "flat-to-flat" Use 10mm hex wrench on top of Double-D socket Use 28mm hex wrench...

Allows replacement of the rear axle carrier ball joint with the carrier in place Services E38, E39, E52, E53, E60, E61, E63, E64, E65, E66 BMW applications include: 528i, 528i wagon, 540i, 540i wagon, 525i, 525i wagon, 530i, 740i, 740il, 750il, all '95...